HEN toll roads WPF-100
HEN WEGENFREES WPF 100
Maintaining semi-paved roads and cycle paths, country roads, shell paths and other semi-paved surfaces is often labour-intensive. To fill washouts, ruts and potholes, new material is generally applied (very high transport and material costs) and levelled with a grader. However, this working method creates little or no bonding between the original top layer and the newly applied material. To achieve good adhesion, loosening the top layer is necessary, mixing it well, and not reducing the particle size.
The HEN WPF 100 achieves this in a single pass. The cutter is infinitely adjustable in depth and rotates against the direction of travel, causing the material to be picked up. Thanks to special chisels and their arrangement on the rotor, the particle size is not reduced and the material is deposited in such a way that the road surface can be laid to profile. A built-in grading blade distributes the material evenly. The built-in hydraulically driven vibrating plates compact the ground so that the road is immediately passable again by bicycle and/or car. Optimal hardening is achieved within a few days, depending on the weather conditions.
Renovating country roads in a single pass — that’s how it works!
• For mounting on tractors from 80 hp
• Maintenance of (semi-)paved surfaces with a particle size from 0 to 60 mm
• The damaged wearing layer is milled loose, rotor rotates against the direction of travel
• Material is mixed and deposited, coarse material underneath covered with a top layer of finer material
• A built-in levelling blade smooths the surface and fills holes
• Two split hydraulically driven plates compact the new profile
• Rotor speed approx. 250 rpm
• The particle size is not reduced
• Working depth infinitely adjustable via a hydraulic top link
• Working depth up to approx. 12 cm, working width 100 cm
Technical specifications HEN WPF 100
- Three-point linkage cat II or III
- PTO drive 540 rpm
- Heavy-duty right-angle gearbox
- Construction of Domex steel, high strength and dimensionally stable
- Wear parts are bolted and easy to replace
- Shear bolt protection for right-angle gearbox in case large stones become jammed
- Hydraulics required from the tractor for the compaction plates
- Milling drum with heavy-duty bearings, chisels with round carbide shank
- 145 chisels
- Milling housing fully lined inside with Hardox wear plates
- Compaction plates mounted in ‘silent’ bearing blocks
- Bolt-on Hardox wear plates on compaction plates
- LxWxH 1,800 x 2,300 x 1,600 mm
- Weight 2,600 kg
In the news: the magazine De Loonwerker also recognizes the advantages of a HEN road planer
"HEN road planers offer an environmentally friendly and cost-saving solution:
Reuse of existing materials, fewer transport movements.
Better water drainage, preventing erosion and puddle formation.
Low maintenance costs thanks to wear-resistant milling teeth.
Lower CO₂ emissions by reducing soil transport."
- De Loonwerker
Do you want to level a gravel road or restore a semi-paved path?
Contact DEKENS for a no-obligation quote, more information or a demonstration.
